Major layer shift mid print @ same level repeatedly - Bambu Lab X1-Carbon - Bambu Lab Community Forum

Howdy mates, need your brains! I’m running the same print on 2 identical printers. Now I noticed a major level shift on the newer X1CC so I stopped and aborted then resumed, the same .stl was sent to both printers and the other prints without this layershift. Got up to check the progress and the very same layer shift poops up again on the same printer again! What is this?!? I need your help mates, I am at a loss and this print is half a roll PetG 😕 (And why is it running fine

Iron Reign Robotics –

Four day old X1C Y axis low - Bambu Lab X1-Carbon - Bambu Lab Community Forum

Artisan Spirit: Spring 2017 by Artisan Spirit Magazine - Issuu

Iron Reign Robotics –

Major layer shift mid print @ same level repeatedly - Bambu Lab X1-Carbon - Bambu Lab Community Forum

MBR Compiled, PDF, Streptococcus

Four day old X1C Y axis low - Bambu Lab X1-Carbon - Bambu Lab Community Forum

Merchant Magazine - August 2006 by 526 Media Group - Issuu

眼镜王蛇 - Школа траблшутеров

PAPERmaking! Vol.6 No.2 2020 by pita.co.uk - Issuu

Causes for layer shift and other issues mid print? : r/BambuLab

Your Ultimate Guide To The Perfect Banner Size

Poor Bed Leveling - Bambu Lab X1-Carbon - Bambu Lab Community Forum, one piece filme reihenfolge zur serie

5º Fest Viola Muniz 2023 – Região do Caparaó Capixaba