Terrible first layer - 3D Printing / 3D Printers - Talk

Hello, I recently bought a Printrbot Play, and I’m experiencing some problems with my first layer. The first layer looks acceptable for small objects, but when I print some bigger objects (with a greater surface) it just looks terrible. As you can see on the picture, it looks like the infill is way to big to fit inside the perimeters of the first layer. It is actually crossing the bottom perimeter, and causing the layer to “wave”. The small square on the left has this issue also, but less

Alex Volkov

Přímá viditelnost Milovaný Děkuji 3d print first layer issues lékárna Start zbytky

res.cloudinary.com/dbshcjrt3/image/upload/w_2400,h

Terrible first layer - 3D Printing / 3D Printers - Talk Manufacturing

CPE / PETG terrible first layer & surface quality - Materials & profiles - UltiMaker Community of 3D Printing Experts

Fix Your 3D Printer First Layer Issues, Z Offset Calibration

Bad looking surface above supports

Přímá viditelnost Milovaný Děkuji 3d print first layer issues lékárna Start zbytky

Wavy first layer on big prints : r/VoxelabAquila

extrusion - First 3 mm prints poorly, then fine after that - 3D Printing Stack Exchange

Přímá viditelnost Milovaný Děkuji 3d print first layer issues lékárna Start zbytky

Curious About 3D Printing? Here Are Some Tips Before You Dive In

7 problems affecting the quality of your 3D prints - Original Prusa 3D Printers

Terrible first layer - 3D Printing / 3D Printers - Talk Manufacturing